Posted by: Rubensx

screws - 01/29/06 03:29 AM

hello Cyberman

i'm brazilian, and don't speek english very well, but i try to be "clean"to you undertaand

I've my dual 800mhz Q.S. motherboard and processor in ATX case, and work fine!


Any processor pin or screws (ground or +12) can't be touch the base of metal under the motherboard...

If you're use the "front panel board" be sure if this board corretly grounded ok?

my Q.S. wont boot when I (swap the screws in processor) and when I wired groun this screws...

I don't know if I be clear or if you understand what i say, but i hope this help tou

best reguards
Posted by: shadowboxer47

Re:screws - 01/30/06 03:10 AM

Thanks for the tip!