I just figured everyone has put out painting mod guides, so I will just show the finished work. As always, the masking was the most important step. I used Pectra trim tape that allows you to curve around the laptop. It was about $3.00 for 20 feet, but it saved alot of time by not having to tear little masking tape pieces to fit around the curves. I also cleaned the whole body with concentrated goo gone before I painted, I usually use it to refinish the rubber parts, but it cleans the plastic good too. The screws I painted just to accent the color a little, without making it look cheap. I'm sure the rubber feet had a purpose, but this laptop is just for internet at this point, so if it gets trashed I just have an excuse to buy a new one.
Xplain's use of MacNews, AppleCentral and AppleExpo are not affiliated with Apple, Inc. MacTech is a registered trademark of Xplain Corporation. AppleCentral, MacNews, Xplain, "The journal of Apple technology", Apple Expo, Explain It, MacDev, MacDev-1, THINK Reference, NetProfessional, MacTech Central, MacTech Domains, MacForge, and the MacTutorMan are trademarks or service marks of Xplain Corp. Sprocket is a registered trademark of eSprocket Corp. Other trademarks and copyrights appearing in this printing or software remain the property of their respective holders.
All contents are Copyright 1984-2010 by Xplain Corporation. All rights reserved. Theme designed by Icreon.