I need to find someone that can assist me on repairing (if possible) the white plug-in attached to the motherboard , where the startup button wire plugs into . The plug-in piece broke off from the motherboard . It looks as if it has 2 contact points where it was soldered onto the board . I need a new plugin part and someone who can solder it on . Is there anyone here who can send me in the right direction ? Please reply me at email@example.com ................. Thanks !!!
Hate to say it, but that piece is hard to come by. Apple ships that board as finished goods to service providers. If you still had the plug, the soldering wouldnt be impossible. Without it though, I dont know how much luck you'll have.
Electricity tastes good. No, seriously.
If you can't find the original jack scavange any small electronics plug of a similar size. Make sure you get both the male and female ends with a few inches of wire still on each. solder one end on an inch or so of wire to the logic board and use the other to go to the button. I don't believe positive and negative will matter for the button though if any one else on the forum would weigh in on that I would appreciate it.
Xplain's use of MacNews, AppleCentral and AppleExpo are not affiliated with Apple, Inc. MacTech is a registered trademark of Xplain Corporation. AppleCentral, MacNews, Xplain, "The journal of Apple technology", Apple Expo, Explain It, MacDev, MacDev-1, THINK Reference, NetProfessional, MacTech Central, MacTech Domains, MacForge, and the MacTutorMan are trademarks or service marks of Xplain Corp. Sprocket is a registered trademark of eSprocket Corp. Other trademarks and copyrights appearing in this printing or software remain the property of their respective holders.
All contents are Copyright 1984-2010 by Xplain Corporation. All rights reserved. Theme designed by Icreon.