You need the sawtooth logic board as well as the front power panel, either an original from another sawtooth or wire your own but the B&W one will not work. Only one or two of the MB standoffs don't line up. Also the rear ports are not the same, just leave the bezel off or make your own from some scrap material. This mod is not to difficult to pull off.
lol i was about to say this. I put the logic board in and then found out about that front panel. :-[ Grrr. I guess I'll wait another week to get that panel shipped from eBay. And on that rear bezel I just used the old B&W one and cut the necessary holes. Thanks for help!
Xplain's use of MacNews, AppleCentral and AppleExpo are not affiliated with Apple, Inc. MacTech is a registered trademark of Xplain Corporation. AppleCentral, MacNews, Xplain, "The journal of Apple technology", Apple Expo, Explain It, MacDev, MacDev-1, THINK Reference, NetProfessional, MacTech Central, MacTech Domains, MacForge, and the MacTutorMan are trademarks or service marks of Xplain Corp. Sprocket is a registered trademark of eSprocket Corp. Other trademarks and copyrights appearing in this printing or software remain the property of their respective holders.
All contents are Copyright 1984-2010 by Xplain Corporation. All rights reserved. Theme designed by Icreon.