Loc: San Francisco, CA
OK... Some info that I hope is accurate:
I seem to have misunderstood in regards to using 167MHz bus speed dauhgter boards in conjunction with a bus speed mod on the mobo to get the 167Mhz bus to work. That's only if you don't want to make mods to the daughterboard.
The only question at this point is, what are the resistors rated at? For the clock speed multiplier resistors, they're 1k ohm. The voltage ones are 47ohms. The bus speed ones? I have no clue.
Also, on the daughter board, the resistors for the spots marked R27, R22, R26 in that order should be empty, empty, resistance. 133 is, in the same order, empty, resistance, resistance.
Hope that info is helpful. I can't see the resistors on the daughter board to guage their rating without pulling off my heatsink, and I'm not going to go that far without doing pretty much all of my overclocking. AND, before I do that, I need to order PC2700 RAM.
DP 1.08GHz PMG4 MDD, 1GB PC2700 DDR, 200GB ATA (16MB, 7200RPM), Radeon 9800 Pro (256MB)
Xplain's use of MacNews, AppleCentral and AppleExpo are not affiliated with Apple, Inc. MacTech is a registered trademark of Xplain Corporation. AppleCentral, MacNews, Xplain, "The journal of Apple technology", Apple Expo, Explain It, MacDev, MacDev-1, THINK Reference, NetProfessional, MacTech Central, MacTech Domains, MacForge, and the MacTutorMan are trademarks or service marks of Xplain Corp. Sprocket is a registered trademark of eSprocket Corp. Other trademarks and copyrights appearing in this printing or software remain the property of their respective holders.
All contents are Copyright 1984-2010 by Xplain Corporation. All rights reserved. Theme designed by Icreon.